Detailed Product Description

. Introduction

Any colorful photos, scenery pictures can be transferred printing into coated plates that are particularly suitable for advertising, gifts, promotion, personalized products etc. Simple and quick operation, continuing working ability and highly automatic property, meanwhile the machine can transfer photo on

Coated board, coated metal board, coated key ring and coated mirror.

. Feature

(1) Meter controller makes the heating effect steadier.

(2) Imported silica gel heating pad is able to endure high temperature. To make the pressure more uniform and will not be metamorphosed when the temperature reaches 240.

(3) Highly electronic resistance equipment which makes the temperature error to be 1.

(4) Convenient to adjust the pressure with the rolling screw.

(5) The biggest transfer size: 8 inch (diameter of the plate)

(6) Preheating time ( Room Temperature of 20): 1-3 minutes. Temperature status will be showed in the mean while.

(7) Fashionable look with small weight makes it flexible to bring with

. Function

1.       Press Handle

2.       Heating Pad

3.       Holder and Pressure Adjusting Screw

4.       Meter Display for Timer

5.       Temperature Indicator

6.       On/off Function for Timer

7.       Power On/Off

8.       Power Indicator

9.       Meter Display for Temperature

. Technical Parameter                       

Voltage: 110v / 220v

Power: 350w

Time Range: 0-99 sec

Temperature Range: 0-240

Size: 40cm (L) x 20cm (W) x 50cm (H)

G.W: 12 KG

. Operation Process

  (1) Mirror prints the picture on normal printing paper with sublimation ink.

    Notice: The machine should be connected with ground wire! Should not have much pressure on the machine, otherwise the heating pad will be metamorphosed. Make sure the size of the photo is the same with the surface of the plate while putting the photo onto the plate.

  (2) Put the picture onto the plate

  (3) Put the plate on the middle part of the plate holder

  (4) Adjust the pressure with the rolling screw under the plate holder

  (5) Hold the plate and press the handle

(6) Set up the heating temperature to 180

(7)     Set up the heating time to 30 s

(8)     Switch on power. (Power indicator will turn on green)

(9)     Waiting until the temperature reach to 180 ( temperature indicator will turn on red )

(10) Switch on timer for heat transferring

(11) Warning automatically after 30 s

(12) Switch the power off

(13) Stretch the handle to open the holder and then take out the plate
(14) Finished photo transferring on plate